Cobra Electronics High Performance 10 Band XR-1010 - Manual (Page 10)

Operation
Selecting Manual Muting Mode
(from Auto mode)
In Manual Mute mode the alerts will always be
heard at the set volume level.
ᕡ Press and release
Mute Button when no
signal is being received.
Muting
Note
The factory default mode
setting is Auto Muting.
Operation
Audio Muting
The Mute button is used to temporarily turn off
the alarm and control Auto Mute mode.
Muting
Note
To completely turn off
incoming alerts while in
auto mode, press and
release mute button.
Note
In either mode the next
alarm will begin with
normal volume. The XR-
1010 will retain the chosen
mode while OFF.
Note
Mute =“Beep”
OR
Auto Mute=“Beep-Beep”
ᕡ Press and release Mute button to turn off
the audio during an alert. The alarm will be
turned off until the incoming audio signal is
over and will reset at previous volume level for
next alert. Pressing Mute button again will
turn alarm back on.
13 12
PRESS &
RELEASE
Manual Muting
Press this button to turn off the audio alarm.
PRESS &
RELEASE
Selecting Auto Muting Mode
(from Manual mode)
In Auto Mute mode the alerts will be heard at the
set volume for 3 seconds, then automatically be
reduced to a lower level.
ᕡ Press and release
Mute button for less than
two seconds when no signal is being received.
All future alarms will be Auto Mute.
In Voice + Tone Mode the message “Mute” or
“Auto Mute” will be heard.