To clean filter, Note, Awarning – Bissell 11323 User Manual
Page 8: Caution, Empty dirt tank, Cleaning or replacing the vacuum filter
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Empty Dirt Tank
The dirt tank needs to be emptied when the dirt
reaches the 'Full' line on the side of the tank.
1. Unplug hard floor cleaner from electrical outlet.
2.
Remove the Easy Empty dirt tank from the
unit by moving the lock button on the front of
the unit to the left.
AWARNING
To reduce the risk of electric shock, turn power switch off
and disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.
3.
Hold the dirt tank over a garbage container.
Press the bottom lid release button on the back
of the dirt tank to empty dirt.
4.
Mount the Easy Empty dirt tank back on the
vacuum base and push the lock button to the
right until it is centered on the front of the unit.
NOTE: The dirt tank may be erashed in warm
water with a mild detergent. Make sure it is
completely dry before replacing.
Cleaning or Replacing the
Vacuum Filter_________________________
The key to maximum performance is having a
clean filter. Cleaning the filter after each use will
help your vacuum operate at peak efficiency.
Use only genuine BISSELL model number 1250
replacement filters in your BISSELL hard floor
.
To clean filter:
1.
Turn power off and unplug unit.
2.
Remove the dirt container from the unit, as
directed above.
3.
Remove filter and tap firmly against the inside
of a waste container, removing any visible dirt.
4.
Replace filters back into the dirt container
and attach dirt container to the base of the unit.
Slide the lever to your right to lock.
NOTE:
• After heavy usage, you may clean the
pre-motor, foam filter by washing it gently
by hand in warm water and mild dish
detergent. Rinse thoroughly and make certain
it is completely dry before replacing it.
• You may replace the paper, pleated filter
when dirty. Recommended replacement is
every 6 months.
Reference page 10 for replacement part
information.
2. T
CAUTION
Upright storage of the cleaner with a wet mop pad may
resuit in the formation of white marks on your floor. To
remove the white marks, clean area with vinegar.
8