Conair EARTHSMART UGH031-0209 - Manual (Page 10)

AT T E N T I O N :
R e a d t h i s s o n o o n e g e t s h u r t
We design equipment with the user’s safety in mind. You can avoid the potential
hazards identified on this machine by following the procedures outlined below and
elsewhere in the User Guide.
W A R N I N G : I m p r o p e r i n s t a l l a t i o n , o p e r a t i o n o r
s e r v i c i n g m a y r e s u l t i n e q u i p m e n t d a m a g e o r
p e r s o n a l i n j u r y.
This equipment should be installed, adjusted and serviced by a quali-
fied technician who is familiar with the construction, operation and
potential hazards of this type of machine.
All wiring, disconnects and fuses should be installed by a qualified
electrical technician in accordance with electrical codes in your region.
Always maintain a safe ground. Do not operate the equipment at power
levels other than what is specified on the machine serial tag and data
plate.
W A R N I N G : V o l t a g e h a z a r d
This equipment is powered by single-phase alternating current,
as specified on the machine serial tag and data plate.
A properly-sized conductive ground wire from the incoming power
supply must be provided. Improper grounding can result in severe
personal injury and erratic machine operation. (Units are supplied with
a grounded plug that must be plugged into a grounded out.)
Always disconnect and lock out the incoming main power source before
opening the electrical enclosure or performing non-standard operating
procedures, such as routine maintenance. Only a qualified technician
should perform troubleshooting procedures that require access to the
electrical enclosure while power is on.
1 - 4 l I n t r o d u c t i o n (continued)