ClearSounds CS-A55 - Manual (Page 6)

6 – ENGLISH 7 – ENGLISH
Telephone Base Installation
choose a location for the base near an electrical outlet and a telephone
jack.
handset batteries MUsT be connected before beginning initial
charging!
1 plug in the ac adapter to the base at the ac plug-in connection.
2 plug the telephone line cord into the telephone jack on the base
3 remove battery compartment cover by sliding it downwards.
4 insert the 3 aaa batteries into the battery compartment – be sure
to observe the correct polarity of the batteries.
Note: Before placing the batteries in the compartment you may want
to activate the auto-amplification mode.
5 replace the battery compartment cover by sliding upward until it
clicks into place.
6 remove the caller iD protection film before using the phone for
the first time.
Handset Battery Charging
1 place the handset into the base. The charge indicator lED on the
base will light rED.
2 iMporTanT: The batteries in the handset must be fully charged
for 24 hours before using the telephone for the first time.
3 after the batteries are fully charged, check for dial tone by pressing
the TALK BUTTON button on the handset.
4 When you place the handset on the base, the battery indicator
lED on the right side of the base will blink, it will check the
battery voltage to determine if the batteries are fully charged.
if the batteries are fully charged the lED will turn off after 2
minutes, otherwise it will continue blinking until the batteries are
fully charged and return to standby (the lED will turn off at this
time).
Low Batteries
When the handset batteries get low during a call, there will be a
warning tone (3 beeps) and the low battery icon will appear on the
caller iD display. End your call by pressing the button to return to
standby mode, and then place on the base to recharge. Make sure the
contact points are touching and the charge indicator lED is lit rED.
The battery level can also be monitored via the battery charge icon.
This icon appears while the phone is in standby mode and indicates
the condition of the batteries. When the handset batteries get low,
cS-a55-TriLingual.indd 6 5/28/08 9:10:30 aM