Multiple communication result report, Multiple communication result report -4 – Canon IMAGERUNNER 2230 User Manual

Page 328

Advertising
background image

Report and List Samples

9-4

9

App

end

ix

Multiple Communication Result Report

This report is used to check whether documents were sent successfully to the
intended destinations when a sequential broadcast transmission was performed.

You can set whether to automatically print a Multiple Communication Result Report
after sending documents. (See "TX Report," on p. 7-3.)

NOTE

•

You can also print a Multi TX/RX Report with an image of the sent original attached to it.
(See "TX Report," on p. 7-3.)

•

The default setting is 'For Error Only'.

■ JOB NO.

The four digit number, that is automatically assigned when the document is accepted for
sending, is printed.

■ DEPT. ID

If Department ID Management is set, the Department ID is printed.

■ PGS.

The number of pages that were sent successfully to the destinations is printed.

■ TX/RX INCOMPLETE

If a transmission is incomplete, the fax number and the name of the destination are
printed. If there is no applicable destination, "_ _ _" is printed.

■ TRANSACTION OK

The fax number and the name of the destination of a completed transmission are printed.
If there is no applicable destination, "_ _ _" is printed.

■ ERROR

If an error in transmission occurs, the fax number and the name of the destination are
printed. If there is no error, "_ _ _" is printed.

Advertising
This manual is related to the following products: