Casio EXILIM EX-Z3000 - Manual (Page 17)

17
Quick Start Basics
3.
Connect the USB
cable to the camera.
The back lamp should
light red, indicating that
charging has started.
The back lamp will go
out when charging is
complete.
It takes about
190 minutes to bring a
fully dead battery to a
full charge.
• A battery that has not
been used for a long
time, or ambient
temperature
extremes can cause
charging to take
longer than normal. If
charging takes longer
than about six hours, a timer will terminate it automatically, even if the battery is
not fully charged. This is indicated by the back lamp flashing red. If the battery
has not been used for a very long time, charging may be terminated
automatically and the back lamp may start flashing red after only about 45
minutes. In either case, disconnect the USB cable from the camera and then
reconnect it to resume charging.
• Note that even while the connector is fully inserted, you
still will be able to see the metal part of the connector as
shown in the illustration.
Back Lamp Operation
Lamp Status Description
Lit Red Charging
Flashing Red
Abnormal ambient temperature,
USB-AC adaptor problem,
battery problem, or charging
terminated by timer (page 119)
Off Charging complete
USB cable
(included with camera)
Making sure that the 6 mark on the camera is aligned
with the 4 mark of the USB cable connector, connect
the cable to the camera.
[USB/AV] port
Small connector
USB-AC adaptor
Back lamp