Cambridge Audio AZUR 551R - Manual (Page 29)

551R azur
29
ENGLISH
For playback the 551R expects you to have an actual physical speaker setup
approximately conforming to one of the layouts as shown below.
For 5.1 setups the situation is simple, the 551R automatically performs any
DTS Speaker Remapping required, mapping any of the 7 incoming
possibilities to this configuration.
For 7.1 there are two alternative speaker setup you might have. These
corresponds to configuration 1 and configuration 5 as above.
Here you need to tell the 551R which configuration best matches your
speaker setup by selecting the DTS-HD speaker menu and selecting the 1 or
5 option.
The 551R can then perform any speaker re-mapping required automatically,
and maps any of the incoming 7 possibilities to whichever one of the two 7.1
possibilities you have.
Note: This feature by its nature only works for 7.1 DTS HD Master Audio or
DTS HD High Resolution Audio bitstreams.
Also note that where the incoming speaker configuration and your physical
speaker configuration actually match the 551R performs no mapping as
you’d expect.
Center
Right (30°)
Left (30°)
Left Surround Rear (150°)
Right Surround Rear (150°)
LFE
5.1
7.1
Configuration 1 or Configuration 5
Advanced Dolby/DTS Setup
Dolby Pro Logic IIx Panorama :
Dolby Pro Logic IIx Centre Width :
Dolby Pro Logic IIx Dimension
:
DTS HD Spkr Remap :
Dolby DRC :
Return : [OSD]
Off
0
3
1
Auto
An IR Emitter Input is provided that allows
modulated IR remote control commands to be
received electrically by the unit. An RS232 port is
also featured which allows the 551R to be controlled
by C.I. systems.
In addition the unit features 'direct' IR/Control codes as well as toggle codes
for some of their features to simplify programming custom installation
systems. Special direct On/Off and Mute commands can be accessed on the
supplied remote control for teaching into C.I. systems as follows:
1.Press and hold the Standby/On button on the remote control. The remote
first generates it's standby (toggle) command. Keep the button held down,
after 12 seconds an AV receiver “On” command will be generated. If the
button is kept held down for a further 12 seconds, an AV receiver “Off”
command is generated.
Repeat this procedure with the Mute, Sub On/Off, Stereo Mono and Tuner
AM/FM buttons to send On/Off commands. The Tuner AM/FM button also
provides unique FM and AM commands to allow switching to a specific band.
A full code table and RS232 protocol for this product is available on the
Cambridge Audio website at www.cambridge-audio.com.
The 551R has a function that preserves the preset memory and other
settings. In the event of a power failure, or if the power cord of the unit is
disconnected from the mains outlet, the back-up memory will preserve the
preset memory for approximately one week. If the power supply is interrupted
for 7 days or longer, the memory settings will be erased.
If it is desired to reset all settings to their factory defaults (or in the unlikely
event that the unit locks up due to an electrical discharge etc), with the unit
on and out of Standby mode press and hold the DVD and Analogue Stereo
Direct buttons on the front panel for three seconds.
“RESET” will appear briefly on the front panel display before returning to
Standby mode.
Reset/Back-up memory
Custom installation (C.I.) use
RS232C