B&C Technologies EDG Dryer Control (DE, DP, DI Series) - Manual (Page 7)

Programming
Machine configuration
Programming includes machine configuration (1 or 2 motors, coin box or no coin box), operating
ranges (the desired settings - language, times), and lastly the definition of the behavior of each
single drying cycle.
All programming phases start by entering the correct password, after which the operator proceeds
to enter the desired parameters.
All programming phases can be stopped at any time by pressing STOP. All parameters entered up
to that point will be stored, except for the current one.
All temperature range values listed in the following tables are expressed in °C. In case the board is
configured for operation in °F, all values will be automatically converted.
The password required to access this phase is 748. Proceed as follows : press keys UP and 1 at the
same time. When the message “PASSWO” is displayed, press ENTER.
The message “00000” appears, press three times the DOWN key to erase three zeroes starting from
the right, then type in “748” and press ENTER. Actual programming starts now.
In the following table, programming is summarized with the message that appears on the display,
the values allowed when programming after pressing ENTER and the meaning of each parameter.
Programming
DISPLAY ALLOWED VALUES DESCRIPTION
DISPLA 0..2 Display mode, showing which data will be displayed during
the drying cycle. Available values are :
0
Residual time/Temperature
1 Residual time
2 Temperature
GET SN Yes/No Coin box operation
INV SN Yes/No Reversing Enable. Yes if the machine is equipped with
reversing, otherwise No.
7