Bradford White ACCESSORY PACKAGES - Manual (Page 35)

Setting the Setback
Control Schedule – Initial Set-up
-35-
Figure 61
Temperature
digits are flashing
Select the Leave Period Water Temperature
Step 13: Using the UP (increase water temperature) or DOWN (decrease water temperature) buttons,
select the desired water temperature for the Leave period. This is shown in Figure 60.
Lock in Leave Period Water Temperature
Step 14: Press the RIGHT (Next) button to lock in the Leave period water temperature, as shown in
Figure 61.
Select the Return Period Start Time
Step 15: Press the UP (increase time by 15 minutes) or DOWN (decrease time by 15 minutes) buttons to
select the Return period start time. The time increments in 15-minute intervals just as it did for the other
periods. This is shown in Figure 62.
Figure 62
Hour & minutes
digits are flashing
Figure 60