Magnum Dynalab MD-807T - Manual (Page 5)

- 5 -
5
UNPACKING YOUR MD Tuner
Carefully inspect all sides of the shipping
carton for damage. If there are marks or
holes in the carton make note of the
location in relation to the unit inside. Any
obvious dents or scuff marks should alert
you to the possibility of damage. Carefully
remove the MD Internet Media Tuner
from the end caps and wrapping, inspect
all sides. Pay special attention to the
corresponding areas on the unit where
damage was found to the shipping carton.
If damage is evident, document the type
and extent of the damage, then repack the
unit and call the dealer.
KINDLY DO NOT SEND THE UNIT
BACK TO THE SHIPPER UNTIL YOU
HAVE BEEN ASKED TO DO SO.
DO NOT DISCARD THE PACKING
MATERIALS AND CARTONS. Should
there be a necessity to return the unit for
any reason, it must arrive safely and
suitably packaged in order for our receiver
to accept it from the carrier. If the unit has
incurred damage as a result of improper
packaging, it is not likely that a claim for
the damage against the carrier will be
successful.
Likewise, we will ship your unit back to
you only in factory-approved packaging,
however, if the unit were to arrive at the
factory on anything other than factory
approved packaging, we reserve the right
to return the unit in factory-approved
packaging and charge the cost of the
packaging to the shipper. This is the only
way we can assure you of a safe return
(damage by carrier excepted).
External resources
To operate the MD 807, the following
external resources are needed:
• a power source (100-240 V mains
supply),
• a wired (Ethernet) or wireless (Wi-
Fi) network (provided through a
router) with appropriate
permissions and password if
necessary (for Internet Tuner and
Network Music player modes),
• broadband Internet access (for
Internet Tuner mode and Internet
Software Update),
• a music library stored on the
network or on a USB mass storage
device (for Music player modes),