myCharge Amp 6000 RFAM-0905 - Manual (Page 4)

6 7
Section III: Charging Devices
When a device is plugged in, AMP 6000 provides charging
power until it is unplugged or the AMP 6000 runs out of
energy. If the AMP 6000 isn't already turned on, press and
hold the AMP power button for 3 seconds to begin
charging.
Up to two devices can be charged simultaneously.
The AMP 6000’s USB ports support the majority of
mobile devices including smartphones, tablets, Bluetooth
headsets, portable navigation devices, MP3 players,
and more.
Section IV: Checking Battery Level
To check how much energy is available, press the
battery level check button. The battery icon will
illuminate accordingly:
Green: 71–100%
Yellow: 41–70%
Red: 11–40%
Flashing Red: 0-10%
After 5 seconds, the LED will turn off.
Section V: Maintenance
To keep your AMP 6000 operating at its full potential,
please do the following:
1. Re-charge every three months when not in use.
2. Keep dry and away from moist and corrosive materials.
3. To clean, wipe surface with dry cloth.
Section VI: Product Specifications
Battery: 6000mAh Lithium Polymer
Micro-USB Input: 5VDC, 1.0A
USB 1 Output: 5VDC, 2.1A
USB 2 Output: 5VDC, 1.0A
Total Output Current: 2.1A
Section VII: Troubleshooting
My device is not charging: Confirm that your device’s
charging cable is properly connected to one of the USB
ports and the AMP itself has energy (by pressing the battery
icon button). If the battery icon is red, there isn’t enough
energy to charge your devices—please recharge.
For additional troubleshooting information and device
compatibility, please visit: www.mycharge.com
ONE YEAR LIMITED WARRANTY
RFA BRANDS sells its products with the intent that they
are free of defects in manufacture and workmanship for
a period of one year from the date of original purchase,
except as noted below. RFA BRANDS warrants that
its products will be free of defects in material and
workmanship under normal use and service. This warranty
extends only to consumers and does not extend
to Retailers.