myCharge Hub 9000 RFAM-0234 - Manual (Page 4)

6 7
Section III: Charging Devices
Hub 9000 uses an automatic device detection system for
the micro USB. When devices are plugged in, Hub 9000
provides charging power until they are unplugged or
the Hub 9000 runs out of energy. When charging devices
through the Apple Lightning connector or USB port, if
the Hub 9000 isn't already turned on, press and hold
the battery icon button for 3 seconds to begin charging.
Up to three devices can be charged simultaneously. The
Hub 9000 Apple Lightning connector is compatible with
iPhone 5 and any other devices with a Lightning connector.
The Micro-USB connector and USB ports support the
majority of mobile devices including smartphones, tablets,
Bluetooth headsets, portable navigation devices, MP3
players, and more.
Section IV: Checking Battery Level
To check how much energy is available, press the
battery level check button. The battery icon will
illuminate accordingly:
Green: 71–100%
Yellow: 41–70%
Red: 11–40%
Flashing Red: 0–10%
After 5 seconds, the LED will turn off.
Section V: Maintenance
To keep your Hub operating at its full potential, please do
the following:
1. Re-charge every three months when not in use.
2. Keep dry and away from moist and corrosive materials.
3. To clean, wipe surface with dry cloth.
Section VI: Product Specifications
Battery: 33.5Wh Lithium Ion
Input:
AC: 100-240 VAC 50/60 Hz
Output:
Apple connector output: 5VDC, 2.1A
Micro-USB output: 5VDC, 500mA
USB output: 5VDC, 1.0A
5VDC, 3.6A Max Total
Section VII: Troubleshooting
My device is not charging: Confirm that your device is
properly connected to the appropriate connector and the
Hub itself has energy (by pressing the battery icon button).
If the battery icon is red, there isn’t enough energy to
charge your devices – please recharge. If multiple devices
are connected, disconnect them and connect only the
device that is not charging.
For additional troubleshooting information and device
compatibility, please visit: www.mycharge.com