Concord Camera Eye-Q Go LCD Camera - Manual (Page 34)

33
Connecting the Camera to the Computer:
1. When the camera is connected to the computer
for the first time, the camera’s driver installation
will begin. Please follow the on-screen
instructions to complete the installation.
2. Plug the rectangular end of the USB cable that is
included with the Concord Eye-Q Go LCD into
your PC’s USB port. (fig.4.1)
3. Open the Cable Connection panel on the Concord
Eye-Q Go LCD, by lifting the door and then
sliding the door out.
4. Plug the square end of the USB cable into the USB connector located
inside the Cable Connection panel.
Unplugging the Camera From the Computer
(Windows ME/2000/XP)
1. Click once on the "Unplug or Eject Hardware" icon on the
right hand side of your task bar. (fig.4.2)
2. Select "Stop Concord Eye-Q Go LCD USB Driver V 0.1".
3. Click [OK] when the "Safe to Remove Hardware" prompt appears.
4. Unplug the USB from the camera.
fig.4.1
fig.4.2
GO LCD Manual-E (511185-00) 5/7/02 6:02 pm Page 33