Battery installation, Preparation for storage – Night Optics D-930 Gen 3 Gated Clip-on Night Vision Scope User Manual
Page 12
10
BATTERY INSTALLATION
1) Remove battery cap by turning counter-clockwise.
2) Inspect compartment for any corrosion and/or moisture.
3) Insert new CR123 Battery into compartment negative end down.
4) Replace battery cap and tighten.
WARNING
Do not carry batteries in pockets containing metal objects such as coins, keys, etc.
Metal objects can cause batteries to short circuit and become very hot.
WARNING
DANGER OF EXPLOSION
Lithium batteries contain sulpher dioxide gas under pressure and should be handled in
the following manner
• Do not heat, puncture, disassemble, short circuit, attempt to recharge, or otherwise
tamper with the batteries.
• Turn OFF the equipment if the battery compartment becomes unusually hot. If
possible, wait until the batteries have cooled before removing them.
• The batteries have safety vents to prevent explosion. When they are venting gas, you
will smell it (very irritating) or hear the sound of gas escaping. When the safety vents
have operated, the batteries are fairly safe from bursting, but will be hot and must be
handled with care.
• If you inhale sulpher dioxide, seek medical attention.
PREPARATION FOR STORAGE
1) Shutdown - Perform the following procedures to shut down the device:
A) Turn the device ON/OFF Switch to the OFF position.
B) Disconnect the device from the scope.
C) Remove battery.
2) Packaging after Use
A) Open battery compartment and remove battery.
B) Inspect the battery compartment for corrosion or moisture. Clean and dry if necessary.
C) Replace the battery cap.
D) Place the device in the carrying case.