Night Optics Krystal 950L Generation 2+ B/W Clip-on Sight - Manual (Page 6)

5 NIGHT VISION
OPERATION
BATTERY INSTALLATION
Remove battery cap (fig. 1-5) by turning counter-clockwise.
Inspect compartment for any corrosion and/or moisture.
Insert new 3v CR123 Battery into compartment negative end down.
Replace battery cap and tighten.
¡WARNING!
Do not carry batteries in pockets containing metal objects such as coins, keys,
etc. Metal objects can cause batteries to short circuit and become very hot.
¡WARNING!
DANGER OF EXPLOSION
Lithium batteries contain sulpher dioxide gas under pressure and should be
handled in the following manner
• Do not heat, puncture, disassemble, short circuit, attempt to recharge, or
otherwise tamper with the batteries.
• Turn OFF the equipment if the battery compartment becomes unusually hot. If
possible, wait until the batteries have cooled before removing them.
• The batteries have safety vents to prevent explosion. When they are venting
gas, you will smell it (very irritating) or hear the sound of gas escaping. When the
safety vents have operated, the batteries are fairly safe from bursting, but will be
hot and must be handled with care.
• If you inhale sulpher dioxide, seek medical attention.
BASIC OPERATING PROCEDURES
Make sure the power switch is in the OFF position.
Install battery as stated in directions
Attach the device in front of the objective of daytime scope.
Turn device ON and make sure device is working properly.
Adjust focus accordingly.