Outdoor Great Room Gallery Wall-Mounted Fireplaces User Manual

Gallery wall-mounted fireplaces

Advertising
background image

90238 Rev B 11/8/12

Gallery Wall-Mounted Fireplaces

Installing the fireplace into a wall as a built-in unit

Included in this kit-

Wall Mounting Brackets (2)

M5x10 Screws (4)

Control button relocation module (1)

Tools Required-

Philips Screwdriver or
power drill with
Philips tip (preferred)

Leveling device

NOTE: Heater unit may be removed or left attached to the fire box for this installation. Use the provided

diagrams for clearances for each configuration.

Removing the heater unit (optional)

Remove 4 screws from underside of heater unit

Unplug the heater from the fire box by
squeezing the tabs on the white quick
connector plug and pulling downward. Set
heater assembly aside or dispose of
appropriately.

Remove

Relocate Heat and lighting controls

Remove the screws holding the access panel on
the underside of the fire box on.

There is a small quick connect plug inside this
access panel. Plug the control module (included
with this kit) into the quick connect plug and
screw access panel back into place, threading
wire through hole in access panel door.

Once fireplace is installed into a wall, the
control button module can be mounted to the
wall surface below it using a screw or a
double-sided adhesive strip.

Connect control button module to

fire box

Remove screws

Advertising