Petsafe 275 m Deluxe Remote Spray Trainer - Manual (Page 9)

www.petsafe.net 9
Care and Cleaning
For comfort, safety, and effectiveness of this product, please ensure that you check the fit of
your pet’s collar frequently. This Guide describes proper collar fitting. If any skin irritation is
observed, discontinue the use of the collar for a few days. If the condition persists beyond
48 hours, see your veterinarian.
To prevent skin irritation from occurring:
• The Receiver Collar should not be worn for more than 8 hours out of every 24-hour period.
• The spray from the Receiver Collar may stick to the hair under your dogs snout. Clean your
dog’s hair weekly with a wash cloth and a mild hand soap. Rinse and dry your
dog’s neck thoroughly.
• If the spray, dirt, or debris accumulates on the Receiver Collar (including the nozzle and Refi ll
Port), wipe the receiver clean with a damp cloth and dry thoroughly.
• It is recommended that the unit be cleaned monthly or as needed to prevent clogging. The need
for cleaning will depend on usage.
Ensure a Proper Spray Pattern
For the PetSafe ® Remote Spray Training Collar to perform
properly, the nozzle must be positioned correctly and there
must be a clear path from the Spray Nozzle to your dog’s
snout. Follow these steps:
1. Make sure the PetSafe
® logo on the front of the unit is upright
and the Spray Nozzle is angled out and pointing up towards the
dog’s snout.
2. For long-haired dogs, it may be necessary to trim the neck hairs
along the path of the spray. It is important that the spray reaches
the dog’s snout to be effective.
• Hold the Unscented Spray can upright and firmly press the nozzle down into the Refill Port. Hold
for 15 seconds and remove. Note: If spray leaks out, you may need to press harder to complete the seal.
To Fill and Refi ll the Unscented Spray
• Remove the collar from your dog.
• Turn the unit off.
• Ensure the Refill Port is clean. Note: If any dirt or debris enters the
Refi ll Port when refi lling, it could cause the unit to become clogged
and malfunction.
• Hold the Unscented Spray can upright and fi rmly press the
nozzle down into the Refi ll Port. Hold for 15 seconds and
remove. Note: If spray leaks out, you may need to press harder to
complete the seal.
• Turn the unit on.
Important: To reset the spray counter, ensure the unit is on.
Press and hold the On/Off Button until the Red and Yellow
LED Lights turn off.
Note: Do not puncture or incinerate the spray collar or the refi ll canister. Do
not expose to extreme heat or store at temperatures above 48° C (120° F).
15 seconds