Petsafe Big Dog Rechargeable Bark Control - Manual (Page 10)

10 www.petsafe.net
EN
FR
NL
ES
IT
DE
The Bark Control Collar has a single Settings Button that allows you to turn the unit on
and off, display or change the current static stimulation mode, and change the static
stimulation level. The following table describes how to perform the different tasks.
Task Steps to perform Indications
Turn the
unit on Press and release the
Settings Button while the
unit is off. The light will fl ash green fi ve
times and then display the
current static stimulation mode.
Turn the
unit off Press the Settings Button
until the Digital Display
goes blank and the red
light appears. Release the
Settings Button.* The light will fl ash red four times
and the unit will turn off.
Display
current static
stimulation
mode Press and hold the Settings
Button for less than 2
seconds before releasing it. The unit will display the current
static stimulation mode and
battery condition.
Change
active static
stimulation
mode 1. Press and hold the
Settings Button for at
least 5 seconds.
Mode will advance and
be displayed.
2. Continue to hold the
Settings Button to
advance to the next
available mode.
Every 2 seconds the mode will
advance and be displayed.
3. When the desired mode
is displayed, release the
Settings Button.
The selected mode will be
displayed during this time.
4. Once the Settings Button
has been released for
5 seconds, the new
static stimulation mode
will activate.
The Digital Display will fl ash four
times and the unit will resume
normal operation using the new
static stimulation mode.**
5. If the Settings Button
is released too early,
simply press it again
within 5 seconds.
The mode will advance and
continue as described in Step 2.
* If you continue to hold the Settings Button for more than 5 seconds, you will begin
changing the static stimulation mode. You must release the Settings Button before
attempting to turn off the unit.
** The light will fl ash every fi ve seconds to indicate the current mode.