Petsafe Drinkwell® Original Pet Fountain - Manual (Page 3)

www.petfountain.com
CLEANING AND MAINTENANCE INSTRUCTIONS
Make certain the cord and plug are dry, then plug into a polarized outlet. (One
slot is larger than the other). The plug will only fit into a polarized outlet. Do
not attempt to force it into an old, unsafe outlet. Use an adapter if necessary.
• There are notches for the power cord on both sides of the bottom of the
fountain.
The notches are a pass-through for the cord. They are not for holding the
cord snugly, which might damage the cord. The cord should be passed
through vertically. DO NOT turn the cord horizontally and FORCE into a
notch as this may damage the cord and create a hazard.
Add more water to the bowl after the unit is primed and running. For quietest
operation, fill bowl completely. A gentle hum during normal operation is to
be expected.
Set the desired flow rate with the flow control knob, which is next to the ramp
in the bowl (minimum rate at 11 o’clock position, maximum rate at 1 o’clock
position).
Add water to the bowl as needed. (The bowl holds 50 oz. of water). During
regular use, do not allow the water level to fall below the inlet grate on the
bottom of the flow control knob, or the motor may run dry.
The Fountain Must Be Cleaned To Continue Working Normally!
Filters should be changed approximately every six to eight weeks. Replace fil-
ters more frequently when using the fountain for dogs. FOR REPLACEMENT
FILTERS, VISIT A PET STORE NEAR YOU OR CALL 866-322-2530.
Filters may be rinsed out when the fountain is cleaned. Do not wash with
soapy water since you cannot remove all the soap residue.
Filters are an added feature of the fountain. Their use is not required for nor-
mal operation.
FILTERS:
3
5.
6.
7.
8.
1.
2.
3.