Petsafe Elite Big Dog Spray Bark Control - Manual (Page 7)

6 www.petsafe.net www.petsafe.net 7
EN
FR
ES
NL
IT
DA
DE
Fit the Bark Control Collar
Important: The proper fit and placement of your Bark Control Collar is important for
effective operation.
Please refer to page 2 for important safety information.
To assure a proper fit, please follow these steps:
1. Make sure that the Bark Control Collar is turned off.
2. Start with your dog standing comfortably (A).
3. Place the Bark Control Collar on your dog’s neck close to the ears.
Center the Sensor Probe underneath your dog’s neck,
touching the skin. Make sure the PetSafe
®
logo in the
front of the unit is upright (B). Note: It is sometimes
necessary to trim the hair around the Sensor Probe to
make sure that contact is consistent.
Do not shave the pet’s neck as this may increase the risk of skin irritation.
4. Check the tightness of the Bark Control Collar by
inserting one finger between the Sensor Probe and
the dog’s neck (C). The fit should be snug but
not constricting.
5. Allow your dog to wear the collar for several
minutes, then recheck the fit. Check the fit again as
your dog becomes more comfortable with the Bark
Control Collar.
6. Trim the collar as follows (D):
a. Mark the desired length of the collar with a pen.
Allow for growth if your dog is young or grows a
thick winter coat.
b. Remove the Bark Control Collar from your dog
and cut off excess.
c. Before placing the Bark Control Collar back
onto your dog, seal the edge of the cut collar by
applying a flame along the frayed edge.
The collar should not be worn for more than 12 hours out of every 24-hour
period. Leaving the collar on too long could lead to skin irritation.
SÍ
NO
A
B
C
D