Petsafe In-Ground Fence™ - Manual (Page 17)

16 1-800-732-2677 www.petsafe.net 17
7. Test in a number of different locations around the
containment area until you are satisfied that the system is
functioning properly.
8. Next, walk all around the Pet Area to ensure there are no
areas where the Receiver Collar may activate from signals
coupled onto buried wires or cables. Test the collar in and
around the inside of the house as well. As mentioned, cable
and wires from cable TV, electrical or telephone lines may
conduct pet fencing signals inside and outside the house
that can activate the dog’s collar accidentally. While rare,
if this occurs your Boundary Wire is probably too close to
these outside lines and should be moved or modified as
shown in Figure 3A.
Boundary
Wire
6G
5
2 8
4
10
3
9 1
7
0
6
5
2 8
4
10
3
9 1
7
0
6
6F
9. To test the run-through prevention feature, walk towards the Boundary Wire. The Receiver Collar should tone
and the Test Light should flash brighter as you enter the run-through area (6G). If you are satisfied that your
system is functioning properly, you are ready to start burying the Boundary Wire. If the Receiver Collar did not
tone or the Test Light did not flash, see the “Troubleshooting” section.