Petsafe Infra Red 4 Way Locking Deluxe Cat Flap - Manual (Page 7)

7
Powering the Infra-red cat fl ap
Remove the battery cover by pushing fi rmly in the direction of the arrows.
(Fig. 9).
Place 4 x AA 1.5V Alkaline Long Life batteries in position. (Fig. 10).
Batteries should be replaced every 3-6 months. Do not use
rechargeable batteries.
After you have powered the cat fl ap it emits a low tone bleep indicating the
cat fl ap is ready for programming. In addition to the bleep the red LED will fl ash.
(Fig. 10).
FIG.9 FIG.10
Powering the Infra-red key
Open the collar key by twisting a coin between the two fl anges (Fig. 11).
Remove battery holder (Fig. 12).
Place 2 x LR44 (A76, SR44, D357/303) coin cell batteries into the battery
holder. The collar key LED will fl ash 3 times indicating that the key is active
(Fig. 13).
Replace battery holder into the clear base. Replace coloured cap by
clipping the two halves of the key together, ensuring that the green circuit
board is visible through the clear base. (Fig. 14).
The key will continue to fl ash at 2 minute intervals (Fig. 15).
FIG. 11 FIG. 12 FIG. 13 FIG. 14 FIG. 15
Batteries should be replaced every 3-6 months or when the
LED stops fl ashing.