Petsafe Innotek Basic In-Ground Fence - Manual (Page 6)

The following instructions apply to the battery-operated collar receiver only. If your collar receiver is
battery-operated, please proceed to Part B below.
The collar receiver is charged via the wall-mount transmitter. To charge the collar receiver for initial
use, you must first install the transmitter.
The rechargeable collar receiver must be charged for at least 12 hours before you use it
for the first time. IMPORTANT! DO NOT BURY THE WIRE UNTIL YOU HAVE TESTED THE
SYSTEM WITH YOUR COLLAR RECEIVER AND ARE SURE IT IS WORKING PROPERLY.
IMPORTANT NOTE: The containment system will not function while the collar receiver
is charging. Therefore you should either plan a) to charge the collar receiver only when
your dog can be supervised or otherwise contained; or b) to purchase an additional collar receiver
and charger from INNOTEK and charge one collar receiver while the
other is in use. To order an additional collar receiver and charger,
contact an INNOTEK Service Center.
To charge the collar receiver:
1. Turn the wall-mounted transmitter on and place the
collar receiver on top of it. Make sure the transmitter’s
raised alignment pin fits into the small indentation on the
bottom of the collar receiver.
2. Check that the transmitter is blinking. This indicates
that the collar receiver is being charged. If the transmitter
is not blinking, check that the transmitter is turned “on” and
check all of the connections.
3. The blinking indicator light will go out when the collar receiver is fully charged.
INNOTEK’s chargers automatically prevent over-charging.
4. Depending on the frequency of correction, the charge in the collar receiver usually
lasts between 2 and 3 weeks.
IMPORTANT NOTE: Do NOT place the collar receiver on your dog until the containment
system has been tested and the signal field adjusted.
5. Proceed to Step 10 below to test your system for proper functioning.
B. Battery-Operated Collar Receiver
The following instructions apply to the battery-operated collar receiver only. If
your collar receiver is rechargeable, please refer to Part A above.
Collar Receiver Battery Installation
1. Place the collar receiver on a flat surface with the battery cap facing up.
2. Using a coin or a screwdriver, unscrew the battery compartment cap.
3. Insert the 6-volt alkaline battery (included) into the battery compartment with
the positive (+) side up.
4. Replace the battery compartment cap. Being careful to keep the cap in contact with the battery,
turn the cap clockwise until it is firmly seated.
5. Depending on the frequency of correction, the battery in the collar receiver usually lasts
6