Petsafe Innotek Cabela’s Gun Dog Remote Trainer - Manual (Page 7)

Cabela’s ® Gun Dog ® — Owner’s Manual 7
USING THE TRANSMITTER
Turning ON the Transmitter
Power up the Transmitter by pressing
any button. You will see the display turn
on when you press any button.
Reset All Programmable Settings
Press and at the same time to
reset all programmable settings to the
d
de effa au ulltt s se ettttiin ng gs s. The Transmitter Display
shows all symbols for two seconds
during reset.
Transmitter Default Settings
GS-6000 Defaults
Dog 1&2 Primary Stim Level: 5
5
GS-7000 Defaults
Dog 1&2 Stim Type: S
Sttiim m w wiitth ho ou utt T To on ne e
Dog 1&2 Primary Stim Level: 7 7
Dog 1&2 Alt Stim Level: 1 14 4
Set Stim Button Intensity Level
To change the intensity level for the Stim
button:
Press or until the desired
stimulation level is displayed. When the
Stim button is pressed, the Receiver will
deliver a stimulation at this setting.
G GS S--7 70 00 00 0 O ON NL LY Y::
Programming Mode
To enter Programming Mode, press and
hold the Prog/Loc button until the PROG
symbol displays, then release the button.
The Transmitter is now in Programming
mode.
To exit Programming Mode, press and
release the Prog/Loc button again. The
PROG symbol no longer displays.
G GS S--7 70 00 00 0 O ON NL LY Y::
Program the Stim Type (Tone Option)
For GS-7000 Transmitters, stimulation
may be delivered with or without a tone.
The Transmitter’s default setting is
Stim
without Tone.
To choose:
1.Choose desired dog. Press
(Dog Select button).
2.Press the Prog/Loc button until the
PROG symbol shows in the Transmitter
display. Release Prog/Loc button.
3.Press and release TONE. If
you keep pressing the
TONE button, the selection
switches between these choices:
• Stim without Tone (
no Tone symbol
displayed)
• Stim with Tone (
Tone symbol displayed)
4.Press and relase the Prog/Loc button
to save setting and exit.
For additional information regarding using
the Tone, see
Training Tone Option on
page 14.
G GS S--7 70 00 00 0 O ON NL LY Y::
Set Dual Dog mode
In Dual Dog mode, the continuous
stimulation button (red) controls Dog 1
receiver collar, and the momentary
stimulation button (gray) controls Dog 2
receiver collar. Lets you control two
dogs without using the Dog Select
button to switch between dogs. In this
mode, Stim type is
stim without tone.
continued on next page