Petsafe Innotek No-Bark Collar - Manual (Page 3)

Proper Fit: The collar fit should be
snug, yet loose enough to allow one
finger to fit between the strap and
dog’s neck. Fit is important because
a loose collar may cause inconsis-
tent performance. It’s okay to trim
any excess strap length.
Your Dog’s First Session
Monitor your dog during his first session. This is when he will learn what the
collar means. Dogs learn at different speeds. It may take several barks or
even several sessions for your dog to reduce his barking. Don’t worry – the
Auto-Set feature starts at the lowest level and will adjust to the right level to
motivate your dog to stop barking. The collar will remember the correct level
between uses.
Resetting the Collar
The BC-200 resets to lowest level each time it is charged. You may also
reset the collar by recharging for as little as 1-minute.
Testing the Collar
You may wish to test the collar from time to time. To test the collar, gently
rub the metal probes against a hard non-glass surface. A solid red LED
indicates that the unit is functioning properly.
Troubleshooting
If the collar appears not to be working, try the following:
• Adjust the collar strap to fit
• Recharge the battery
• Check that the probes are tightened
• Ensure that the probes are touching the dog’s skin
• If necessary, trim the dog’s hair or use the longer probes to
ensure proper skin contact.
If you cannot solve the problem by following these steps,
please call 800-826-5527.
Components
The BC-200 has a waterproof collar that can be submerged in water during
a dog’s normal activities; do not place in a dishwasher.
Two sets of probes are included so you can choose what’s right for your
dog’s coat.
The BC-200 is powered by a rechargeable NiMH battery. When the battery
is low and needs to be charged, a red light will flash once every five sec-
onds. The red light will glow steadily while being charged.
FREE Professional Training Support
Additional behavior or training issues? Looking for the best way to
get a well-behaved dog? Just call our FREE Professional Training Support
hotline at 800-364-3362 and speak with the professionals
at Dogstar Training.
Visit www.partnersinbehavior.com
This Innotek Free Spirit Bark Collar is designed to meet requirements set
forth by United States country telecommunications authorities. Note that in
some countries use may be limited due to national frequency planning
requirements. The user is responsible for respecting those rules.
Step 1
Adjust the Collar
BC-200 Automatic No-Bark Collar
Rechargeable
Quick Start Guide
Step 3
Using the Collar
Step 2
Power Up
The collar is activated when the
unit is charged. Simply put the collar
on your dog and enjoy the peace
and quiet. Innotek’s Auto-Set
feature will do all the work.
Charge the collar for 14-16 hours.
Be sure to cover the charge jack
with the gray plug when done.