Petsafe Innotek UltraSmart Contain ‘n’ Train In-Ground Fence Extra Collar - Manual (Page 2)

Splice each end of your pet fencing loop wires to the twisted wire.You
must use the supplied waterproof splices. Connect the lead ends of
the twisted wire to the wall mount transmitter. Plug in the AC Adapter
and connect it to the transmitter. Turn the transmitter ON. The trans-
mitter’s green light should illuminate, indicating a successful contin-
uous loop.
Run the containment wire around the property as outlined in your plan. Use
gradual rounded corners with wide radiuses. Avoid sharp (90°) angles.
Step 3
Lay Out the Fence Wire
Step 2
Install the Wall-mount transmitter
Step 1
Design Your Fence
Quick Start Guide
IUC-4100, IUC-4200, IUC-5100, IUC-5200
Have the local utility companies mark your underground lines; in
most communities this is a free service. On a sheet of paper, sketch
your house and yard. Draw a line around your property that repre-
sents the containment area for your dog, avoiding underground
utility lines. Where it is not possible to avoid utility lines, run your
wire perpendicular to the underground lines.
Locate the transmitter indoors on an exterior wall near an AC power
outlet; inside a garage or basement is ideal. The containment twisted
wire will need to run from the transmitter and pass through a window
or small drilled hole to the outdoors.
Step 4
Final Connections
1
Boundary Wire
Splice
To wall-mount transmitter
INNOTEK ® UltraSmart In-ground Pet Fencing Systems
Boundary Wire
10’
10’
Bur
ied Cab
le
90˚
Page 5
Page 6
Page 6
Page 7
Follow Page Numbers For Detailed Instructions
About Your INNOTEK ® UltraSmart ™
In-Ground Pet Fencing System
Discover what a difference an in-ground fencing system can make. You’ll discover
the ease and convenience of keeping your dog safe in your yard without the structure
and expense of traditional fencing.
Collar Charging Station plugs into any 110 v AC wall
outlet. The collar fits in the cradle and charges the col-
lar in just 2-3 hours. It’s an attractive unit designed for
use in your home.
The Wall-mount transmitter controls the fencing field.
Mount it indoors, with field wires passing through the wall
and buried in the ground. You set controls to adjust the
size of the fencing field, strength of correction, and more.
Lightning Protection is an important part of your system.
This module is connected between the loop wire and the
transmitter. Without lightning protection, a lightning strike
within 1-2 miles of your installation can surge through
loop wire or AC power and may damage your transmitter.
Lightning protection is included in IUC-4200, IUC-5100,
and IUC-5200, and many other INNOTEK
® fencing sys-
tems. Lightning protection module is also available as a
separate purchase; call us at 1-800-826-5527.
Boundary Wire is burial grade and rugged for virtual-
ly any ground conditions. You’ll lay the wire about 3-
inches deep. Twisting the boundary wire creates areas
in your yard that the dog can safely pass over. Pre-
twisted FasTrak
™ is included in IUC-4200, IUC-5100,
IUC-5200 and many other Innotek fencing systems.
ABOUT ZONES
Your dog’s collar will also work with the Zones ™
system, indoor avoidance to keep your dogs away
from things in your home. See page 9.
The UltraSmart Collar has been designed by profes-
sionals to offer optimal training stimulation in a sleek,
low profile design. The collar is packed with features
including PerfectFit
™ , an indication that the collar is fit-
ted properly to your dog.
You MUST charge
collar for 3 hours prior
to first use.
Important: Never leave the collar on the dog
for more than 12 consecutive hours.
See “Important Advice”, page 3.