Petsafe Outdoor Bark Control - Manual (Page 7)

www.petsafe.net 7
Regular Maintenance
• Remove the battery before cleaning.
• Clean the PetSafe Outdoor Bark Control with a damp cloth.
• Do no use any kind of spray chemicals or solvent to clean.
• Do not immerse in water or any other liquid.
Note: the Outdoor Bark Control is weatherproof. However, if water enters into the microphone it may
disrupt the unit’s operation. After the microphone is dry it will resume working properly.
____________________________________________________
To Test the Outdoor Bark Control
1. Turn the Mode Switch to TEST.
2. Hold the unit with the Indicator Light facing towards you. The unit should be arms length
away from your mouth.
3. In order to trigger the unit, say “Woof ” loudly towards the Microphone.
4. The LED light will flash red and there will be an audible sound to indicate that it is
functioning properly.
5. If the Indicator Light does not flash and there is no audible sound, ensure that the battery
is properly installed and/or replace the battery. If the Indicator Light still does not flash,
contact the Customer Care Center at 1-800-732-2677.
6. Return the Mode Switch to Low Sensitivity before you begin using the Outdoor Bark
Control. Note: The TEST Mode is not intended for normal operation. If the Outdoor Bark
Control is left in TEST Mode, it can send false signals and may reduce battery life.
____________________________________________________
Accessories
To purchase additional accessories for your PetSafe ® Outdoor Bark Control, contact the
Customer Care Center at 1-800-732-2677 or visit our website at www.petsafe.net to locate a
retailer near you.
Component Part Number
Battery Door RFA-277