Petsafe Ultralight™ Add-A-Dog® Extra Receiver Collar User Manual
Page 5
www.petsafe.net 5
Place the Receiver Collar on your pet so that the
3.
“PetSafe” logo is facing your pet’s chin. Center
the Contact Points underneath your pet’s neck,
touching the skin. Note: It is sometimes necessary to
trim the hair around the Contact Points to make sure
that contact is consistent.
Check the tightness of the Receiver Collar
4.
by inserting one fi nger between the end of
a Contact Point and your pet’s neck. The fi t
should be snug but not constricting (E).
Allow your pet to wear the collar for several
5.
minutes then recheck the fi t. Check the fi t again
as your pet becomes more comfortable with the
Receiver Collar.
F
E
Once you are satisfi ed with the fi t of the Receiver Collar then you may trim any
6.
excess collar strap as follows (F):
Mark the desired length of the Receiver Collar with a pen. Allow for growth if
a.
your pet is young or grows a thick winter coat.
Remove the Receiver Collar from your pet and cut off the excess.
b.
Before placing the Receiver Collar back onto your pet, seal the edge of the cut
c.
collar by applying a fl ame along the frayed edge.