Petsafe VT-800 Remote Vibration Trainer - Manual (Page 16)

16 www.petsafe.net www.petsafe.net 17
DE
FR
ES
NL
IT
EN
Adding Dog 2
Remote Transmitter
1. Set the Level Select Switch to 2.
2. Press and hold the Dog Select Button continuously for 5 seconds.
(The Green LED will flash 3 times.)
3. Press and release the Transmitter’s Dog Select Button and ensure
the Green LED flashes one time to indicate Dog 2 is set.
Receiver Collar
1. With the Receiver Collar in the off position, press and hold the
On/Off Button continuously for 5 seconds. The Green LED will
flash once per second even after the button is released for up to
10 seconds.
2. During this 10 second programming mode, press and release the
Transmitter’s Dog Select Button once. (This sends the Transmitter’s
unique ID to the Receiver.)
3. The Green LED light on the Receiver Collar will flash 5 times.
The new ID is now set. To verify press the Top Button (light blue)
on the Transmitter.
Multi-Dog Functions
1. To select between Dog 1 and Dog 2, press and release the Dog
Select Button to toggle back and forth between Dog 1 (Red LED)
and Dog 2 (Green LED).
2. The Transmitter will remember the last dog selected.
To Reprogram Back to 1 Dog Mode
1. Set the Level Select Switch to 1.
2. Press and hold the Dog Select Button continuously for 5 seconds.
The Red LED will flash 3 times when it is complete.