Ryobi P310G - Manual (Page 5)

5 – English
ASSEMBLY
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
OPERATION
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this tool for the following purposes:

Sealing cracks to keep your home’s conditioned air inside
while keeping unconditioned air outside, increasing your
home’s energy efficiency
 Filling holes and cracks before painting
 Creating a moisture barrier around areas that could be
damaged by water
 Sealing cracks to keep insects from crawling inside your
home
 Applying adhesive
TO INSTALL/REMOVE BATTERY PACK
See Figure 1, page 9.
To install:

Lock the switch trigger by sliding the switch lock up.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in the
product before beginning operation.
To remove:

Lock the switch trigger by sliding the switch lock up.
 Depress the latches on the side of battery pack.
 Remove the battery pack from the tool.
WARNING:
Battery products are always in operating condition.
Therefore, the switch should always be locked when not
in use or carrying at your side.
LOCKING THE SWITCH TRIGGER
See Figure 2, page 9.
The switch trigger can be locked off using the slide switch
located below the switch trigger.

To lock the switch trigger, slide the switch lock up. This
will prevent the switch trigger from being depressed.
 To unlock the switch trigger, slide the switch down. This
will allow the switch trigger to be depressed.
STARTING/STOPPING THE CAULK GUN
See Figure 2, page 9.
Before attempting to start the caulk gun, be sure the switch
lock is in the unlocked position.

To turn the caulk gun ON, depress the switch trigger.
 To turn the caulk gun OFF, release the switch trigger.