Ryobi RY10532 - Manual (Page 9)

9
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
NOTE: The chain saw has been fully factory tested. It is
normal to find some slight oil residue on the saw. Read
and remove all hang tags and store with the Operator’s
Manual.
KNOW YOUR CHAIN SAW
See Figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator’s manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
CHOKE KNOB
The choke knob opens and closes the choke valve in the
carburetor. Positions available include FULL CHOKE, HALF
CHOKE, and RUN.
COMBINATION WRENCH
A combination wrench tool is provided for use when per-
forming various maintenance procedures. On-board storage
keeps the tool handy at all times.
CHAIN BRAKE / FRONT HAND GUARD
The chain brake is designed to quickly stop the chain from
rotating. When the chain brake / front hand guard is pushed
toward the bar, the chain should stop immediately. The chain
brake does not prevent kickback.
GUIDE BAR
The factory-equipped guide bar has a small radius tip that
offers a somewhat lower kickback potential.
LOW KICKBACK SAW CHAIN
The low kickback saw chain helps minimize the force of a
kickback reaction by preventing the cutters from digging in
too deeply at the kickback zone.
PRIMER BULB
The primer bulb pumps fuel from the fuel tank to the
carburetor.
SAFE-T-TIP ANTI-KICKBACK NOSE GUARD
The SAFE-T-TIP Anti-Kickback Nose Guard is an attach-
ment provided on the end of the guide bar to prevent the
chain on the end of the guide bar from contacting the
wood.
THROTTLE TRIGGER
The throttle trigger is used for starting the chain saw, and
also for controlling chain rotation.
UNPACKING
This product has been shipped completely assembled.

Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list are
included.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
PACKING LIST
Chain Saw
Scabbard
Combination Wrench
2-Cycle Engine Oil
Operator’s Manual
Case
FEATURES
ASSEMBLY