Ryobi CSB1308 - Manual (Page 2)

2
REPLACING LOWER BLADE GUARD HANDLE
See Figure 4.
■ Using a Phillips screwdriver, remove the two screws that
secure lower blade guard handle to lower blade guard.
■ Remove and discard your original lower blade guard
handle.
■ Position your new replacement lower blade guard handle
on lower blade guard as shown in figure 4.
Note: The new handle can be identified by the red marking
on the inside of the handle.
■ Secure lower blade guard handle to lower blade guard
using the two Phillips head screws removed above.
■ Tighten screws securely.
WARNING:
Failure to securely tighten lower blade guard handle
screws could result in serious personal injury.
■ Reinstall blade on your circular saw. See Figure 5. Refer
to your saw’s operator’s manual.
■ Place the outer blade washer and spring washer in place.
■ Tighten the blade bolt securely, using the 9/16 in. blade
wrench supplied with your saw.
WARNING:
Failure to place the outer blade washer and the spring
washer in place or failure to tighten the blade bolt securely
could result in serious personal injury.
■ Check for smooth operation of lower blade guard before
plugging saw into power supply.
Fig. 4
LOWER BLADE GUARD
LOWER BLADE
GUARD HANDLE
LOWER BLADE
GUARD HANDLE
SCREWS
WASHER
WASHER
Fig. 5
SPINDLE
LOWER BLADE
GUARD HANDLE
BLADE
OUTER BLADE
WASHER
("D" WASHER)
BLADE
SCREW
SPRING
WASHER
INNER FLANGE BUSHING
(MODELS CSB130, CSB130JS AND CSB1308)
INNER BLADE WASHER
(MODEL CSB120)
IF YOU EXPERIENCE ANY PROBLEMS OR NEED FURTHER ASSISTANCE
WITH MAKING THE REPAIRS IN THIS KIT, CALL 1-800-867-9624.