Ryobi CSB132L - Manual (Page 21)

21
0° BEVEL STOP
See Figure 24.
The saw has a 0° bevel stop that has been factory adjusted to
assure 0° angle of the saw blade when making 90° cuts.
TO CHECK 0° BEVEL STOP
 Unplug the circular saw.
 Place the saw in an upside down position on a
workbench.
 Check the squareness of the saw blade to the base of
the saw using a carpenter’s square.
TO ADJUST 0° BEVEL STOP
 Unplug the circular saw.
 Loosen bevel adjustment knob.
 Turn set screw with hex key and adjust base until it is
square with the saw blade.
 Tighten bevel adjustment knob securely.
WARNING:
Attempting a bevel cut without having the bevel
adjustment knob securely tightened can result in serious
injury.
ADJUSTMENTS
51.5
45
30
Fig. 24
BEVEL
ADJUSTMENT KNOB
CARPENTER’S
SQUARE
SET SCREW