Ryobi CS120L - Manual (Page 11)

11
OPERATING THE SAW
See Figures 11 - 12, pages 14 - 15.
It is important to understand the correct method for operating
the saw. Refer to the figures in this section to learn the correct
and incorrect ways for handling the saw.
WARNING:
To make sawing easier and safer, always maintain proper
control of the saw. Loss of control could cause an
accident resulting in possible serious injury.
DANGER:
When lifting the saw from the workpiece, the blade is
exposed on the underside of the saw until the lower blade
guard closes. Make sure the lower blade guard is closed
before setting the saw down.
To make the best possible cut, follow these helpful hints.

Hold the saw firmly.
 Avoid placing your hand on the workpiece while making
a cut.
 Support the workpiece so that the cut (kerf) is always to
your side.
 Support the workpiece near the cut.
 Clamp the workpiece securely so that the workpiece will
not move during the cut.
 Always place the saw on the workpiece that is supported,
not the “cut off” piece.
 Place the workpiece with the “good” side down.
 Draw a guideline along the desired line of cut before
beginning your cut.
CROSS CUTTING/RIP CUTTING
See Figure 13, page 16.
When making a cross cut or rip cut, align the line of cut with
the outer blade guide notch on the base.
Since blade thicknesses vary, always make a trial cut in scrap
material along a guideline to determine how much, if any, you
must offset the guideline to produce an accurate cut.
NOTE: The distance from the line of cut to the guideline is
the amount you should offset the guide.
RIP CUTTING WITHOUT AN EDGE GUIDE
See Figure 14, page 16.
Use a guide when making long or wide rip cuts with the
saw.
NOTE: You may also use an edge guide to make rip cuts.
Refer to
Rip Cutting with the Optional Edge Guide later
in this manual.
OPERATION
 Secure the workpiece.
 Clamp a straight edge to the workpiece using
C-clamps.
 Saw along the straight edge to achieve a straight rip
cut.
NOTE: Do not bind the blade in the cut.
BEVEL CUTTING
See Figure 15 - 16, page 16.

Align the line of cut with the inner blade guide notch on
the base when making 45° bevel cuts.
 Make a trial cut in scrap material along a guideline to
determine how much you should offset the guideline on
the cutting material.
 Adjust the angle of the cut to any desired setting between
zero and 45°. Refer to Adjusting the Bevel Setting.
ADJUSTING THE BEVEL SETTING:

Loosen the bevel lock .
 Raise the motor housing end of the saw until you reach
the desired angle setting on the bevel angle scale.
 Tighten the bevel adjustment lock knob securely.
WARNING:
Attempting a bevel cut without having the bevel adjust-
ment lock knob securely tightened can result in serious
injury.
BEVEL CUTTING:

Hold the saw firmly as shown.
 Rest the front edge of the base on the workpiece.
 Start the saw and let the blade reach full speed.
 Guide the saw into the workpiece and make the cut.
 Release the trigger and allow the blade to come to a
complete stop.
 Lift the saw from the workpiece.
POCkET CUTTING
See Figure 17, page 16.
WARNING:
Always adjust bevel setting to zero before making a
pocket cut. Attempting a pocket cut at any other setting
can result in loss of control of the saw possibly causing
serious injury.
 Adjust the bevel setting to zero.
 Set the blade to the correct blade depth setting.
 Swing the lower blade guard up using the lower blade
guard handle.
NOTE: Always raise the lower blade guard with the handle
to avoid serious injury.