Ryobi CSB135L - Manual (Page 8)

8 - English
 Depress and hold spindle lock.
 Remove blade screw by turning it counterclockwise
with the blade wrench, while keeping the spindle lock
depressed.
 Remove spring washer and then remove outer blade
washer (“D” washer).
 Lift lower blade guard.
 Remove blade.
 Depress spindle lock and replace blade screw.
 Tighten blade screw securely by turning it clockwise with
the blade wrench.
NOTE: Never use a blade that is too thick to allow the
outer blade washer (“D” washer) to engage with the flat
on the spindle.
To remove the blade:
 Unplug the saw.
ASSEMBLY
WARNING:
This product and some dust created by power sanding, sawing, grinding, drilling, and other construction activities may
contain chemicals, including lead, known to the State of California to cause cancer, birth defects, or other reproductive
harm.
Wash hands after handling.
Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products and,
• arsenic and chromium from chemically treated lumber.
Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your
exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially
designed to filter out microscopic particles.
CALIFORNIA PROPOSITION 65
OPERATION
DANGER:
Keep hands away from cutting area and the blade.
Keep your second hand on the front handle, or motor
housing. If both hands are holding the saw, they cannot
be cut by the blade.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
APPLICATIONS
You may use this product for the purposes listed below:

Cutting all types of wood products (lumber, plywood,
paneling, composition board, and hard board)
 Cross cutting/rip cutting wood products
 Bevel cutting wood products
 Pocket cutting wood products
WARNING:
Never use abrasive cut-off wheels of any kind with this
saw. Use of non wood cutting blades can result in property
damage or serious personal injury.
KICKBACK
See Figures 4 - 7, page 16.
Kickback occurs when the blade stalls rapidly and the saw
is driven back towards you. Blade stalling is caused by any
action which pinches the blade in the wood.