Adjustments, Warning – Ryobi C358 User Manual
Page 11
Page 11
0
1
5
ADJUSTMENTS
Fig. 6
ADJUSTABLE FENCE
See Figure 6.
The adjustable fence is located at the rear of your cut-off
machine. As mentioned previously, it is used along with the
vise clamp to provide a clamp for holding your workpiece
securely when making cuts. It also makes your cut-off
machine more versatile.
The fence can be rotated to obtain cutting angles from 0
°
to
45
°
. It also can be moved back to allow greater cutting widths
in thin stock, or forward to allow greater cutting depths in tall
or thick stock.
CUTTING ANGLE ADJUSTMENT
See Figures 6 and 7.
■
Unplug your cut-off machine.
WARNING:
Failure to unplug cut-off machine could result in accidental
starting causing possible serious personal injury.
■
Using the 8 mm hex key supplied, loosen the two socket
head bolts securing adjustable fence.
See Figure 7.
■
Rotate fence until the desired angle of cut on the scale is
aligned with the indicator in machine base.
■
For precise cuts, check the angle of cut for the fence
against the abrasive wheel with a protractor, bevel square,
or other similar device.
■
Using the 8 mm hex key supplied, securely tighten socket
head bolts. Return hex key to its storage area in base.
■
This will secure the fence in place at desired angle.
See Figure 6.
ADJUSTING WIDTH OF CUT
See Figures 7 and 8.
■
Unplug your cut-off machine.
WARNING:
Failure to unplug cut-off machine could result in accidental
starting causing possible serious personal injury.
■
To increase the width of cut of your cut-off machine, use
the 8 mm hex key to loosen and remove the socket head
bolts and washers securing fence to machine base.
■
Reposition the curved slot of the fence with the threaded
hole in back of the machine base.
■
Install a socket head bolt through a lock washer and flat
washer into machine base. Do not tighten bolt securely.
■
Align remaining fence bolt hole with the middle threaded
hole in the machine base.
■
Install socket head bolt through lock washer and flat
washer into machine base.
■
Check and adjust fence to desired cutting angle.
Fig. 7
Fig. 8
ADJUSTABLE
FENCE
SCALE
INDICATOR
ADJUSTABLE
FENCE
FENCE
SCALE
VISE
CLAMP
SOCKET HEAD
BOLTS
SOCKET HEAD
BOLTS
ADJUSTABLE
FENCE
THREADED
HOLE