Specifications – Classe Audio CA-2100 User Manual

Page 22

Advertising
background image

22

Specifications

Classé Audio reserves the right to make improvements without notice.

■

Power output

100W/ch continuous rms @ 8Ω

(both channels driven)

200W/ch continuous rms @ 4Ω

■

Frequency response

10Hz – 22kHz (+0/-0.1dB)

10Hz – 155kHz (+0/-3.0dB)

■

Phase

better than -10° @ 22kHz

■

Signal-to-noise ratio

better than -105dB

(ref. full ouput, 10Hz – 80kHz)

■

Channel separation

better than 110dB @ 20kHz

■

Noise floor (FFT)

all peaks less than -95dBV

(10Hz – 80kHz)

■

Distortion (THD + noise)

0.003% @ 8Ω

(unweighted, 1.0Vrms/1kHz input, 10Hz – 500kHz)

■

Voltage gain

29.1dB

■

Sensitivity

1.0Vrms for rated output @ 8Ω

■

Input Impedance

100kΩ

■

Rated power consumption (as per IEC60065 para. 2.3.10)

260W

■

Idle power consumption

104W

■

Mains voltage

specified on rear panel

(cannot be changed by dealer or user).

■

Dimensions (not incl. controls or connectors)

Width: 17.5” (445mm)

Height: 4.75” (121mm)

Depth: 16.5” (419mm)

■

Shipping weight

55 lbs (25kg)

■

Net weight

47 lbs (21kg)

For more information, see your Classé dealer, or contact:

Classé Audio
5070 François Cusson
Lachine, Quebec
Canada H8T 1B3
Telephone

+1 (514) 636-6384

FAX

+1 (514) 636-1428


http://www.classeaudio.com
email: [email protected]



Classé and the Classé logo are trademarks of Classé Audio Inc. of Lachine, Canada. All rights reserved.
i-Command™ is a trademark of Equity International, Inc. All rights reserved.
AMX

®

is a registered trademark of AMX Corporation of Richardson, TX. All rights reserved.

Crestron™ is a trademark of Crestron Electronics, Inc. of Rockleigh, NJ. All rights reserved.

Advertising