Adjustments – Ryobi JS451L User Manual
Page 16
16 — English
ADjUSTMENTS
WARNING:
Before performing any adjustment, make sure the product
is unplugged from the power supply and the switch is in
the
OFF ( O ) position. Failure to heed this warning could
result in serious personal injury.
TIGHTENING bASE ADjUSTMENT LEVER
See Figures 15 - 16.
The base adjustment lever may need occasional
tightening.
Unplug the saw.
If attached, remove the vacuum attachment.
Remove the base plate screws and base plate by remov-
ing the four base screws to expose the adjusting nut.
Release the base adjustment lever by pulling it forward.
Tighten the adjusting nut 1/4 of a turn in the clockwise
direction.
Engage the adjustment lever by pushing it back under
the motor assembly and check the base for any move-
ment.
If the base is still loose, release the adjustment lever and
tighten the adjusting nut another 1/4 of a turn. Repeat
until the base is secure after engaging the adjustment
lever.
Reinstall the base plate and four base plate screws.
bAsE plATE
Fig. 15
AdJUsTiNg NUT
Fig. 16
bAsE
plATE sCrEWs
bAsE