Ryobi TS1342L - Manual (Page 16)

16
ASSEMBLy
WARNING:
Make sure the spindle lock button is not engaged
before reconnecting saw into power source. Never
engage spindle lock button when blade is rotating.
INSTALLING / REPLACING THE BLADE
See Figures 11 - 12.
WARNING:
A 10 in. blade is the required blade capacity of the saw.
Never use a blade that is too thick to allow outer blade
washer to engage with the flats on the spindle. Failure to
do so can result in serious personal injury.
 Unplug the saw.
 Once blade has stopped, raise saw arm.
 Rotate lower blade guard up and remove screw. Rotate
blade bolt cover up and back to expose the blade bolt
(hex hd.).
 Depress the spindle lock button and rotate the blade bolt
until the spindle locks.
 Using the wrench provided, loosen and remove the blade
bolt.
NOTE: The blade bolt has left hand threads. Turn blade
bolt clockwise to loosen.
 Remove laser guide. Do not remove inner blade washer.
 Wipe a drop of oil onto inner blade washer and laser guide
where they contact the blade.
WARNING:
If inner blade washer has been removed, replace it before
placing blade on spindle. Failure to do so could cause an
accident since blade bolt will not tighten properly.
 Fit saw blade inside lower blade guard and onto spindle.
The blade teeth point downward at the front of saw as
shown in figure 12.
 Replace laser guide. The double “D” flats on the blade
washers align with the flats on the spindle.
 Depress spindle lock button and replace blade bolt.
NOTE: The blade bolt has left hand threads. Turn blade bolt
counterclockwise to tighten.
Fig. 11
SpindLe
Lock button
CAUTION:
Always install the blade with the blade teeth and the
arrow printed on the side of the blade pointing down at
the front of the saw. The direction of blade rotation is also
stamped with an arrow on the upper blade guard.
 Tighten blade bolt securely.
 Replace the lower blade guard and blade bolt cover.
 Replace screw and tighten securely.