Assembly – Ryobi TS1343L User Manual
Page 17
17
ASSEMBLY
WARNING:
Make sure the spindle lock button is not engaged
before reconnecting saw into power source. Never
engage spindle lock button when blade is rotating.
NOTE:
Many of the illustrations in this manual show only
portions of the compound miter saw. This is intentional so
that we can clearly show points being made in the illustra-
tions.
Never operate the saw without all guards securely
in place and in good operating condition.
SQUARING THE MITER TABLE TO THE FENCE
See Figures 15 - 18.
Unplug the saw.
Push down on the saw arm and pull out the lock pin to
release the saw arm.
Raise saw arm to its full raised position.
Loosen the miter lock handle approximately one-half turn.
Depress the miter lock plate and rotate the miter table
until the scale indicator on the control arm is positioned
at 0
°
.
Release the miter lock plate and securely tighten the miter
lock handle.
Lay a framing square flat on the miter table. Place one
leg of the square against the fence. Place the other leg
of the square beside the throat plate in the miter table.
The edge of the square and the throat plate in the miter
table should be parallel as shown in figure 15.
If the edge of the framing square and the throat plate in
the miter table are not parallel as shown in figures 16 and
17, adjustments are needed.
Using the blade wrench, loosen the socket head screws
securing the fence. Adjust the fence left or right until the
framing square and throat plate are parallel.
Retighten the screws securely and recheck the fence-to-
table alignment.
VIEW OF MITER TABLE SQUARE WITH FENCE
VIEW OF MITER TABLE NOT SQUARE WITH FENCE,
ADJUSTMENTS ARE REQUIRED
VIEW OF MITER TABLE NOT SQUARE WITH FENCE,
ADJUSTMENTS ARE REQUIRED
MITER
LOCK HANDLE
MITER
FENCE
MITER
TABLE
THROAT PLATE
FRAMING
SQUARE
Fig. 15
Fig. 16
Fig. 17
SCALE
INDICATOR
MITER
LOCK HANDLE
MITER
FENCE
MITER
TABLE
THROAT PLATE
FRAMING
SQUARE
SCALE
INDICATOR
MITER
LOCK HANDLE
MITER
FENCE
MITER
TABLE
THROAT PLATE
FRAMING
SQUARE
SCALE
INDICATOR