Ryobi TSS100L - Manual (Page 16)

16
ASSEMBLy
WORK CLAMP
See Figure 11.
WARNING:
In some operations, the work clamp assembly may
interfere with the operation of the blade guard assembly.
Always make sure there is no interference with the blade
guard prior to beginning any cutting operation to reduce
the risk of serious personal injury.
The work clamp provides greater control by clamping the
workpiece to the fence or the saw table. It also prevents the
workpiece from creeping toward the saw blade. This is very
helpful when cutting compound miters. Depending on the
cutting operation and the size of the workpiece, it may be
necessary to use a C-clamp instead of the work clamp to
secure the workpiece prior to making the cut.
To install the work clamp:
 Place the work clamp shaft in one of the holes located
behind the miter fence. Tighten work clamp knob
securely.
 Rotate the knob on the work clamp to move it up or down
as needed.
TABLE EXTENSIONS
See Figures 12 - 13.
To install table extensions, insert the ends of extensions into
the holes in the sides of the base. Adjust the extensions to
the desired length.
To secure table extensions:
 Loosen lock nut.
 Tighten table extension screw securing the table
extension.
 Retighen lock nut.
 Repeat for other extension.
Fig. 11
BaSe
work
ShaFt
knoB
Fig. 12
Fig. 13
Saw Viewed FroM BottoM
taBle
eXtenSion
BaSe
BaSe
taBle
eXtenSion
work
claMP
taBle eXtenSion
Screw
lock nut