Waterworks R.W. Atlas Two Hole Bridge High Profile Kitchen Faucet, Metal Side Mount Levers and Spray - Manual (Page 2)

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
RW ATLAS
Two Hole Kitchen Mixer with Spray
INSTALLATION GUIDELINES
Page 2 of 2 8.13.2012
These guidelines have been prepared for the professional contractor to aid in the installation of:
RW ATLAS TWO HOLE KITCHEN MIXER WITH SIDE MOUNT LEVER HANDLES AND SPRAY
(STYLE # RWKM10).
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
SEE SERVICE PART DOCUMENT FOR PART ORDERING, AVAILABLE ON WATERWORKS.COM
7. Slide the retaining collar over the conical end of the
handshower hose and insert the hose into the plastic
sleeve. Pass the knurled end of the hose through the
threaded tube until the plastic sleeve is fully seated
inside the threaded tube. Thread the retaining collar
back onto the threaded tube.
8. Thread the hex collar up until it touches the
retaining collar, then fully tighten the nut to secure
the assembly to the deck.
9. Connect the conical end of the hose to the side
spray.
10. Connect the knurled end of the handshower hose to
the male end of the check valve housing.
Figure - 02
THREADED
TUBE
SIDE SPRAY
SIDE SPRAY HOSE
RETAINING COLLAR
PLASTIC SLEEVE
RUBBER
WASHER
NUT
CHECK VALVE
HOUSING
HEX COLLAR
HEX COLLAR O-RING
ESCUTCHEON
O-RING
INSPECT THE INSTALLATION:
11. Connect the hot and cold inlet hoses to supply
valves (Sold Separately).
12. Remove the flow restricting aerator using a flat head
screwdriver or a coin, then carefully open the hot
and cold valves to flush out any debris in the supply
lines. (See Figure - 01).
13. Inspect all connections for leaks.
14. Re-install the flow restricting aerator making sure
the washer is in place.
15. Make sure the hoses are tight and are not
pinched/kinked.
¾ The hex collars on the bottoms of the handle
assembly, and the bottom of the side spray deck
return can be rotated after installation to orientate
the hexes so they are straight.
¾ NOTE: The screws on the top of the handles are
aesthetic and do not serve any mechanical purpose
and should not be removed.
* Putty contains oils and can cause permanent
discoloration on certain materials such as marble,
granite and any porous surface.
¾ If further assistance is required, please contact
Product Support at 1-800-927-2120 (8am-6pm EST).
¾ See service part document for parts ordering,
available on WATERWORKS.COM.