Waterworks Ludlow Pressure Balance with Diverter Trim with Metal Lever Handle - Manual (Page 3)

LUDLOW
Pressure Balance with Diverter Trim
INSTALLATION GUIDELINES
Page 3 of 3 10.30.2013
These guidelines have been prepared for the professional contractor to aid in the installation of:
LUDLOW PRESSURE BALANCE TRIM WITH LEVER HANDLE WITH DIVERTER (STYLE# LDPB30)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
¾ See Figure 5. for Step 8 - 11.
8. Slide the NOSE CONE CAP over the VALVE STEM
and into NOSE CONE.
9. Remove SET SCREWS from HANDLE ASSEMBLY.
10. Insert the HANDLE ASSEMBLY onto the valve stem
until it is fully seated, making sure it is in the correct
orientation.
11. While holding the HANDLE ASSEMBLY (i), slide the
NOSE CONE CAP back out to reveal the set screw
holes. Tighten both SET SCREWS (ii) and return
NOSE CONE CAP to complete this installation (iii)
For details refer to Figure 5a.
Figure 5
VALVE STEM
NOSE CONE CAP
SET SCREWS
NOSE CONE
HANDLE ASSEMBLY
Figure 5a
TIGHTEN
SET
SCREWS
NOSE
CONE CAP
i ii iii
¾ NOTE: The screws on the trim plate are aesthetic
and do not serve any mechanical purposes and
should not be removed.
¾ Note: There is a notch on the bottom of the TRIM
PLATE for easy removal.
¾ If further assistance is required, please contact
Product Support at 1-800-927-2120 (9am-6pm EST).