Coleman 9995A - Manual (Page 10)

10
Step 3
■ Remove Regulators from
Propane Cylinder Connection.
■ Remove Grease Pans. Slide
out from front of grill to clean or
install new aluminum liners in
Grease Pans.
Step 4
■ Unlock tab as shown.
■ Slide out Grease Tray.
■ Clean thoroughly before storing grill.
Step 5
■ Slide Grease Tray back into position
under grill and lock tab.
■ Turn Righthand Burner Valve to
“High.”
■ Press Igniter Button to light.
NOTE : If the flame doesn’t imme-
diately light, turn off control knob
and wait five minutes for gas to
clear.
■ Repeat steps 1 through 3.
■ If the burner does not light on
second try, turn off knob and
try match-lighting the burner.
■ Repeat steps 2 and 3 for Lefthand
L.P. gas cylinder and Lefthand Burner.
NOTE : You must push Igniter Button
to ignite the second side of the grill.
Step 3
■ All Burner Valves can be adjusted
from “Low” to “High.”
■ Make sure Burner Valves are in
OFF position.
■ Allow unit to cool completely.
■ Turn off fuel supply on both L.P.
gas cylinders.
Step 1
Step 2
Lighting the Grill
continued
Tear Down/Clean
continued
Tear Down/Clean
Match Lighting
■ Use a LONG wooden match or the match extension provided.
Make sure all burner controls are off except one being lighted.
■ Insert a match in the holder end of the extension, strike the
match and place the match near the burner from above.
■ Turn on BURNER CONTROL KNOB while holding match near burner.
■ You must use another match to ignite the second side of the grill.