Chemtronics Chemask® Peelable CM8 - Manual (Page 2)

APPLICATION METHOD
Squeeze Bottle/Syringe Yes
Spatula Yes
Screening No
Automatic Dispensing Yes
Removal/Clean-up By Hand
USAGE INSTRUCTIONS
For industrial use only.
Read MSDS carefully prior to use.
Chemask

solder masking agent is
engineered for all electronic manufacturing
applications. When applying by hand using
squeeze bottle or spatula, insure that all areas
of the pretinned hole are evenly covered on
the side to be soldered. Automatic
dispensing equipment may also be used as
appropriate.
REMOVAL: After allowing the mask to
become fully cured, peelable solder mask
can be removed by hand or by the use of
tweezers. Depending on ambient conditions,
peelable mask may remain on assemblies for
extended periods of time prior to component
insertion.
AVAILABILITY
CM8
8 oz. Squeeze Bottle
CM1 1 Gal. Liquid
TECHNICAL & APPLICATION
ASSISTANCE
Chemtronics provides a technical hotline to
answer your technical and application related
questions. The toll free number is: 1-800-
TECH-401.
ENVIRONMENTAL IMPACT DATA
ENVIRONMENTAL IMPACT DATA
CFC 0.0% VOC 3.1%
HCFC 0.0% HFC 0.0%
Cl. Solv. 0.0% ODP 0.00
CFC, HCFC, CL. SOLV., VOC, and HFC numbers
shown are the content by weight. Ozone depletion
potential (ODP) is determined in accordance with the
Montreal Protocol and U.S. Clean Air Act of 1990. The
ODP of this product is 0.0. It is the sum of the ODP of
the substances that may contribute to the depletion of
stratospheric ozone, based upon the weight of each
substance in the product’s formulation.
NOTE:
This information is believed to be accurate. It is
intended for professional end users having the
skills to evaluate and use the data properly.
CHEMTRONICS does not guarantee the
accuracy of the data and assumes no liability in
connection with damages incurred while using it.
CHEMTRONICS
8125 COBB CENTER DRIVE
KENNESAW, GA 30152
1-770-424-4888
REV. F (08/13)
Chemtronics

and Chemask

are registered trademarks
of Chemtronics. All rights reserved.
DISTRIBUTED BY: