Cambridge SoundWorks NEWTON MC650HD - Manual (Page 10)

10
Warning About Excessive Amplifier Distortion:
Operating a receiver (of any power rating) beyond its
maximum undistorted output level creates distortion –
added high frequency sound not part of the musical program.
Distortion dramatically increases the internal operating tem-
perature of a speaker and will eventually cause the speak-
er’s failure due to burned or melted internal parts. While
Cambridge SoundWorks includes the most heat-tolerant
parts commensurate with good acoustic design, the
speaker’s Limited Warranty against defects in materials or
workmanship does not apply to parts that fail from long-
term operation at very high temperatures.
Enclosure Cleaning
The speaker enclosures can be cleaned with a soft, damp
cloth or mild cleaner.
Brush or vacuum the grille panels with a soft brush
attachment to your vacuum cleaner.
Specifications
Dimensions: 25-3/8" H x 7-1/8" W x 3-15/16" D
Weight: 14-1/2 pounds each
Impedance: nominal 8 ohms
Recommended amplifier power range: 20W – 100W RMS
per channel.
Frequency Range: 80Hz – 24kHz.
Woofer Type: 4 x 3-1/2" with co-injection molded composite
cones and butyl-rubber surrounds.
Tweeter Type: 1/2" aluminum dome with ferrofluid-damping
and neodymium magnet.
Crossover: 2-1/2 way, series-connected with selectable
wall-mounting compensation.
Enclosure: High-density pressure-cast aluminum with
molded-composite baffle.
SPECIFICATIONS
2a
2b
1
1/4"
BRAND
AF6 TM ALLIGATOR ®
Solid-Wall Anchors
Drill 1/4" diameter hole — minimum hole
depth
1 1 /
2 ". Insert anchor and tap flush.
Place item over anchor. Insert screw and
tighten flush. For best results use screw
gun for installation in solid walls.
In walls of minimum thickness 3/8",
screw opens anchor and locks securely.
Patented under U.S. Patent Nos. 4,752,170 and
5,161,296; and foreign counterparts thereof.
Other patents pending. TOGGLER and typeface,
and ALLIGATOR are worldwide registered
trademarks of Mechanical Plastics Corp.
© 2002 MPC
®
Appendix