Chemtronics Electro-Wash PR ES1603 - Manual (Page 7)

Electro-Wash® PR
8. Exposure controls/personal protection
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists or
dusts. If contact is possible, the following protection should be worn, unless the
assessment indicates a higher degree of protection: chemical splash goggles.
Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before
handling this product.
When there is a risk of ignition from static electricity, wear anti-static protective clothing.
For the greatest protection from static discharges, clothing should include anti-static
overalls, boots and gloves. Eyes
Skin
:
:
Environmental exposure
controls : Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
Liquid. [Aerosol.]
0.67
>1 [Air = 1]
32.9 kPa (247 mm Hg) [room temperature]
Mild. Hydrocarbon.
Colorless.
>1 (butyl acetate = 1)
9. Physical and chemical properties
Physical state
Relative density
Vapor pressure
Vapor density
Evaporation rate
Odor
Color
:
:
:
:
:
:
:
Flash point : Closed cup: <-18°C (<-0.4°F)
Flammable limits : Lower: 1.2%
Upper: 7%
Type of aerosol : Spray
Heat of combustion : 29.59 kJ/g
Aerosol product
The product is stable.
Reactive or incompatible with the following materials: Alkaline. Strong oxidizing materials
Under normal conditions of storage and use, hazardous decomposition products should
not be produced.
Avoid all possible sources of ignition (spark or flame). Do not spray on a naked flame or
any incandescent material. Do not pressurize, cut, weld, braze, solder, drill, grind or
expose containers to heat or sources of ignition. open flames, sparks and static
discharge
10. Stability and reactivity
Chemical stability
Conditions to avoid
Incompatible materials
Hazardous decomposition
products
:
:
:
:
Possibility of hazardous
reactions : Under normal conditions of storage and use, hazardous reactions will not occur.
11. Toxicological information
Acute toxicity
acetone LD50 Oral Rat 5800 mg/kg -
n-hexane LC50 Inhalation Gas. Rat 48000 ppm 4 hours
LD50 Oral Rat 15840 mg/kg -
Product/ingredient name Result Species Dose Exposure
Conclusion/Summary : Not available.
Chronic toxicity
7/12 3991 7/22/2013.