Chemtronics Max-Kleen Mighty Wash ES3294 - Manual (Page 3)

Max-Kleen™ Mighty Wash™
Use an extinguishing agent suitable for the surrounding fire.
5. Fire-fighting measures
Extinguishing media
Promptly isolate the scene by removing all persons from the vicinity of the incident if
there is a fire. No action shall be taken involving any personal risk or without suitable
training.
In a fire or if heated, a pressure increase will occur and the container may burst.
Special protective
equipment for fire-fighters Fire-fighters should wear appropriate protective equipment and self-contained breathing
apparatus (SCBA) with a full face-piece operated in positive pressure mode. :
Special exposure hazards :
None known.
Suitable :
Not suitable :
Hazardous thermal
decomposition products : Decomposition products may include the following materials:
carbon dioxide
carbon monoxide
Flammability of the product :
No action shall be taken involving any personal risk or without suitable training.
Evacuate surrounding areas. Keep unnecessary and unprotected personnel from
entering. Do not touch or walk through spilled material. Avoid breathing vapor or mist.
Provide adequate ventilation. Wear appropriate respirator when ventilation is
inadequate. Put on appropriate personal protective equipment (see Section 8).
Stop leak if without risk. Move containers from spill area. Approach release from
upwind. Prevent entry into sewers, water courses, basements or confined areas. Wash
spillages into an effluent treatment plant or proceed as follows. Contain and collect
spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or
diatomaceous earth and place in container for disposal according to local regulations
(see Section 13). Dispose of via a licensed waste disposal contractor. Contaminated
absorbent material may pose the same hazard as the spilled product. Note: see
Section 1 for emergency contact information and Section 13 for waste disposal.
Environmental precautions
6. Accidental release measures
: Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains
and sewers. Inform the relevant authorities if the product has caused environmental
pollution (sewers, waterways, soil or air).
Personal precautions :
Large spill :
Stop leak if without risk. Move containers from spill area. Dilute with water and mop up
if water-soluble. Alternatively, or if water-insoluble, absorb with an inert dry material and
place in an appropriate waste disposal container. Dispose of via a licensed waste
disposal contractor. Small spill :
Methods for cleaning up
Store in accordance with local regulations. Store in original container protected from
direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials
(see Section 10) and food and drink. Separate from acids. Keep container tightly
closed and sealed until ready for use. Containers that have been opened must be
carefully resealed and kept upright to prevent leakage. Do not store in unlabeled
containers. Use appropriate containment to avoid environmental contamination.
Put on appropriate personal protective equipment (see Section 8). Eating, drinking and
smoking should be prohibited in areas where this material is handled, stored and
processed. Workers should wash hands and face before eating, drinking and smoking.
Remove contaminated clothing and protective equipment before entering eating areas.
Do not get in eyes or on skin or clothing. Do not ingest. Avoid breathing vapor or mist.
If during normal use the material presents a respiratory hazard, use only with adequate
ventilation or wear appropriate respirator. Keep in the original container or an approved
alternative made from a compatible material, kept tightly closed when not in use. Keep
away from acids. Empty containers retain product residue and can be hazardous. Do
not reuse container.
7. Handling and storage
Handling
Storage
:
:
3/9 3294 7/29/2013.