Chemtronics Konform Ultra CTUFD-12 - Manual (Page 2)

COMPATIBILITY
Konform® Ultra Conformal Coating is
generally compatible with most materials found
on printed circuit boards. As with any chemical
product, product/component compatibility must
be determined on a non-critical area prior to use.
USAGE INSTRUCTIONS
For industrial use only.
Read MSDS carefully prior to use.
Before applying Konform® Ultra Conformal
Coating, clean circuit boards thoroughly to remove
oil, grease, dirt, flux and all other types of
contamination. Allow to dry. Cleaning may be
performed with Chemtronics

Electro-Wash

or
Eco-Rite™ degreasing products.
SPRAY APPLICATION: Apply top to bottom,
allowing coating to flow evenly around components.
Rotate PCB 90
° and repeat application. Rotate and
apply coating two additional times, then allow board
to cure. If additional thickness is desired, apply
additional coatings. When using liquid spray with
automatic dispensing equipment, adjustments may
be required in application rate and viscosity.
DIP APPLICATION: Using automatic equipment
or hand immersion technique, slowly immerse PCB
into the coating and remove slowly. Use an average
rate of approximately 1 foot per minute. After
allowing the board to cure, process may be repeated
to achieve desired thickness.
BRUSH APPLICATION: Evenly apply coating to
areas desired at thickness required. Allow time for
curing before reapplying to achieve a thick coating.
Use Chemask® to protect components during
conformal coating process.
REMOVAL: After application, cured Konform®
Ultra Conformal Coating may be removed by
soaking in acetone or Chemtronics Electro-Wash

Two Step.
AVAILABILITY
CTUFD-12 11.5 oz. Aerosol
CTUFD1 1 Gallon Liquid
CTUFD5 5 Gallon Liquid
CTUFD55 55 Gallon Liquid
TECHNICAL & APPLICATION ASSISTANCE
Chemtronics provides a technical hotline to answer
your technical and application related questions.
The toll free number is: 1-800-TECH-401.
NOTE
: This information is believed to be accurate. It
is intended for professional end users having the skills to
evaluate and use the data properly. CHEMTRONICS
does not guarantee the accuracy of the data and assumes
no liability in connection with damages incurred while
using it.
Chemtronics
, Chemask 
, Konform® and Electro-Wash

are registered trademarks of Chemtronics. All rights reserved.
Eco-Rite™ is a trademark of Chemtronics. All rights reserved.
CHEMTRONICS
8125 COBB CENTER DRIVE
KENNESAW, GA 30152
1-770-424-4888
REV. B (08/13)
Performance
Moisture Resistance Good
Removability Excellent
Ease of Repair Excellent
Flexibility Fair
Adhesion Excellent
Abrasion Resistance Excellent
Solvent Resistance Fair
DISTRIBUTED BY: