Pro-Link Lithofin KLF Crystallization Fluid 120055 - Manual (Page 3)

Material Safety Data Sheet
Printed: 08.11.2004
Revised: 03.11.2004
Lithofin KLF
3
Components with limit values that require monitoring at the workplace:
The product does not contain any relevant quantities of materials with critical values that have to be
monitored at the workplace.
Additional information:
The lists that were valid during the creation were used as basis.
Personal protective equipment
General protective and hygienic measures
Keep away from foodstuffs, beverages and feed.
Wash hands before breaks and at the end of work.
Avoid contact with the eyes and skin.
Do not eat or drink while working.
The usual protective measures based on the application have to be followed.
All protective equipment used shall be according to 29 CFR.1910 Subpart I Personal Protective
Equipment
Breathing equipment:
Not necessary if room is well-ventilated.
Short term filter device:
Gas filter: E (colour code yellow)
A respiratory protection program that meets OSHA's 29 CFR 1910.134 and ANSI Z88.2 requirements
or European Standard EN 149 must be followed whenever workplace conditions warrant a respirator's
use.
Always use a NIOSH or European Standard EN 149 approved respirator when necessary.
Protection of hands:
Wear chemically resistant protective gloves (tested according to DIN EN 374)
The glove material has to be impermeable and resistant to the product/ the substance/ the
preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
After use of gloves apply skin-cleaning agents and skin cosmetics.
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of
quality and varies from manufacturer to manufacturer.
Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves and has
to be observed.
Eye protection: Chemical safety goggles
Body protection: Acid resistant protective clothing
—————————————————————————————————————————————
9 Physical and chemical properties:
General Information
Form: Liquid
Color: Whitish
Odor: Nearly odorless
Value/Range Unit Method
Change in condition
Melting point/Melting range:
undetermined
Boiling point/Boiling range: > 90 ° C
Flash point:
Not applicable
Auto igniting:
Product is not self igniting.
Danger of explosion:
Product does not present an explosion hazard.
Density:
at 20 ° C ~ 1.0 g/cm³